Publicidad
Idiomas disponibles
Idiomas disponibles
Reference Signal
The HyperDeck Extreme Control features reference in and reference out connections on the
rear panel to allow synchronous recordings.
If you are using an external reference source, connect your reference signal from the 'ref out'
of your reference device or deck to the 'ref in' on the controller.
Selecting your Devices
Now that your RS-422 devices and video signals are attached, it's time to select them on the
HyperDeck Extreme Control front panel. Choose you record and playback deck by selecting
the numbered soft touch button in the playback or record row.
1
On the front panel of the controller, press the button numbered '1' on the top row.
This selects the tape deck you previously connected into the first RS-422 connection as
your playback deck. The button surround will illuminate green.
2
Press number '2' button on the second row to select the HyperDeck Extreme as your
'record' deck. The button surround will illuminate red to indicate this deck is the recorder.
1
1
1
1
1
The green number 1 button indicated the playback deck,
IN
the red button 2 indicates the recording deck.
Using the M button you can control multiple decks at once. Simply hold down the M button and
press the numbers for the decks. It's worth noting that once you've selected multiple decks, the
INPUT
timecode and status indicators will display the lowest numbered deck selected. For example, if
you have selected numbers 2,3 and 4 as playback decks, the status and timecode will display
deck number 2. See 'using the multi deck feature' later in this manual for more information.
EDIT
To select multiple playback decks, hold down the M button so it
illuminates and then press the deck numbers you wish to select.
Controlling your playback and record decks
Once your playback and record decks are connected and selected, you will be able to switch
control between the two by using the soft touch 'player' and 'recorder' buttons on the front
panel above the status indicators. When remote is enabled, you can then use the search dial
and transport controls to navigate to the location on your deck.
1
Press the soft touch 'player' button and the player button will illuminate. The timecode
display and deck status indicator LEDs on the controller will update to show the ref, servo
and remote status of the playback deck. If you press 'recorder', the displays will update to
show the status of the HyperDeck recorder.
PLAYBACK
2
2
3
3
4
4
5
5
2
2
2
3
3
4
4
5
5
RECORD
ENTRY
OUT
TRIM
DELETE
PREROLL
SKIP
REC
EJECT
REW
PLAY
6
6
7
7
8
8
M
M
6
6
7
7
8
8
M
M
PLAYER
RECORDER
SKIP
REF
SERVO
REMOTE
F FWD
STOP
HyperDeck Extreme Control Workflow
HOURS
MINUTES
SECONDS
SHUTTLE
JOG
POSITION
FRAMES
71
Publicidad
