Publicidad
Idiomas disponibles
Idiomas disponibles
DRAWER SLIDE INSTRUCTIONS (ALL UNITS) CONT.
INSTALLING THE DRAWER SLIDE ONTO THE CABINET
• Insert the rear slide tab into the rear slot of the cabinet wall
• Lift the slide slightly, then press it down against the side of the
cabinet wall to engage the front and middle tabs into their slots
• Push down until snap-in tab is securely in place
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
22
REPLACING A DRAWER
• Align drawer slides
• Insert slides
• Push drawer fully into cabinet. This will require enough force to fully
seat the ball bearing slides. After initial set, slide will operate freely
IMPORTANT
Ball retainer on right side drawer slide MUST be up against
the front stop or damage can occur.
INSTALLATION
LOCK CORE INSTRUCTIONS (ALL UNITS)
KEY ALIKE YOUR TOOL STORAGE
• Remove core from lock
B
A
STEP 1: Using the key
STEP 2: Push in
STEP 3: Turn the key
with the same code
firmly on key (A).
another 45 degrees
as the lock, turn the
Rotate free-spinning
(4:30 o'clock) and
lock to the locked
collar until the
remove key and plug
(3 o'clock) position
center of the lock
moves inward (B)
REPLACE CORE WITH ANOTHER KEYED
ALIKE CORE
With the key at the 4:30 o'clock position in
the core, insert the core into the lock.
While pushing in on the key and core, turn
the key 45 degrees counter-clockwise to
the 3 o'clock position and remove key.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
INSTALLATION
WORK SURFACE INSTALLATION
INSTRUCTIONS (ALL UNITS)
Installation may vary depending on work surface being installed.
If necessary, refer to instructions included with specific work surface.
Do not install or store this product where it will be exposed
to rain, snow, or wet conditions.
• Remove all items from top of roll cab, including top mat
• Using two people, lift work surface onto roll cab
NOTE: Set work surface in place at a slight angle to keep
from pinching fingers!
23
Publicidad
