Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY SET UP INSTRUCTIONS CONT.
LATCH AND DRAWER TRIMS
To remove latches from drawer trim, start by removing the screw
shown below. Once removed, the latch can be disassembled from
the drawer trim.
38
EPIQ trim comes as an assembly with an upper and lower trim piece.
The upper trim slides onto the lower trim and is held in place by the
latch. Once the latch is removed as shown, trim assembly can be slid
off of the drawer and individual trim pieces can be removed.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
EPIQ SERIES
EPIQ LOCKER DOOR TRIM ADJUSTMENT
REMOVE OOR PULL TRIM SCREWS
Remove the six (6) screws using a T25 torx driver.
ADJUST TRIM LOCATION
Slightly rotate the trim to allow it to freely move.
Slide the trim either up or down to adjust alignment.
1
2
REINSTALL SCREWS
Reinstall the six (6) screws using a T25 torx driver.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
39
Publicidad
