Publicidad
Idiomas disponibles
Idiomas disponibles
WORK SURFACE INSTALLATION INSTRUCTIONS (ALL UNITS)
Align top over roll cab. Fasten work surface to roll cab through
(2) holes, using hardware provided. Partially open drawer to access
screw location.
Secure with hex washer head cap screw and flat washer
similar to illustration.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
24
Push steel template against the back and side of work surface (A).
Template
A
A
INSTALLATION
WORKCENTER SETUP INSTRUCTIONS (ALL UNITS)
Using a center punch, mark the (2) hole locations. Rotate the
template and repeat on the other end of the work surface.
Step 2: Drill
Step 1: Punch
Using 11/64" drill bit provided, drill (4) holes.
INSTALLATION
Using the #12 drill point screws and washers provided,
fasten into (4) drilled holes.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
25
Publicidad
