Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY SET UP INSTRUCTIONS
TOP CHEST, DRAWER SECTION, & OVERHEAD
Remove top mat from roll cab or drawer section.
NOTE: If a rubber mat or a stainless/wood top is on the unit,
it must be removed to access the mounting holes.
Lift top chest, drawer section, or overhead into place.
NOTE: Two or more people may be necessary for installation
as these accessories are heavy.
Using the quick disconnect tabs on the top drawer slides,
remove top drawer(s) to access the mounting hardware locations.
Fasten units together at the two front and two rear locations using
the hardware provided.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
34
ACCESSORY SET UP INSTRUCTIONS CONT.
LOCKERS AND END CABS
Jack end of roll cab up slightly (approximately 1") to align
handle holes (door not shown below for clarity).
EPIQ SERIES
EPIQ SERIES
Position jack under center cross channel of roll cab as shown below:
Bottom view of EPIQ roll cab
Locate jack under center cross channel
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
35
Publicidad
