Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY SET UP INSTRUCTIONS CONT.
Bolt locker to roll cab at handle hole location using
(2) 5/16-18" X 1-1/8" hex flange screws (1-01816A).
2X
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
36
Secure locker to WorkCenter, drawer section,
or top chest at upper location (when available).
On WorkCenter, secure locker at upper hole location using
(2) 5/16-18" x 1-1/8" hex flange screws (1-01816A) and
(1) 5/16-18" hex flange nuts (1-8933).
On drawer section and top chest, nut may not be needed.
EPIQ SERIES
ACCESSORY SET UP INSTRUCTIONS CONT.
Secure locker to roll cab at lower location.
Jack end of roll cab up slightly higher to take pressure off of casters.
Remove inside shipping caster plate to access lower hole location in
locker and roll cab.
6X
NOTE: Casters should always be installed in the outer position,
furthest away from the roll cab as shown above. Since accessories
may be installed on either side of the roll cab, the casters may have
to be removed and re-installed following the above steps.
EPIQ SERIES
Secure locker at lower hole location using (2) 5/16-18" x 1-1/8" hex
flange screws (1-01816A) and (2) 5/16-18" hex flange nuts (1-8933).
Roll Cab
NOTE: End cabs are as high as the roll cab and only require
to be screwed in at the handle holes and lower hole locations.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
37
Publicidad
