Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLE MOUNTING INSTRUCTIONS
• Align handle guide pins with guide pin holes in the side of the roll cab
• Insert socket head screws and lockwashers through handle holes and tighten
• Affix Snap-on
nameplate decals over die cast screw holes
®
• Cover handle holes on opposite side of roll cab with hole plugs, if desired
Guide Pin Holes
42
Lock Washers
Screws
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
MASTERS SERIES
TRIM & TRIM CAP SERVICE INSTRUCTIONS
Start by drilling out the rivets at the top and bottom of each
trim piece. Once the rivets are drilled out, the trim cap can be
removed by hand.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
MASTERS SERIES
After the rivets and trim caps are removed, rotate the trim piece away
from the unit to completely remove.
New trim can be installed by following the instructions in reverse
order. Start by putting the trim on the unit. Then put the trim cap back
on the top of the trim, being sure to have the hole line up with the
rivet hole in the trim. Rivet the trim in both locations.
43
Publicidad
