Snap-On EPIQ Serie Manual Del Usuario página 9

DRAWER SLIDE INSTRUCTIONS (ALL UNITS)
REMOVING A DRAWER USING THE QUICK DISCONNECT TABS
• Empty drawer contents
• Pull drawer out to full length
• Pull quick release tab on slides
• Remove drawer
20
REMOVING THE DRAWER SLIDE FROM THE DRAWER
• Insert prybar between slide and drawer as shown and gently pry
• Tap the slide down to free up the first two tabs
• Pull the drawer slide forward to free the rear tab
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
INSTALLATION
REMOVING THE DRAWER SLIDE FROM THE CABINET
• Extend slide
• Insert prybar behind slide as shown and gently pry
• Push up as shown to free up the front and middle tab
• Pull slide forward to remove
INSTALLATION
INSTALLING THE DRAWER SLIDE ONTO THE DRAWER
• Insert drawer slide into rear tab
• Pivot drawer slide into middle and front slots until it locks in place
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
21