Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY SET UP INSTRUCTIONS
TOP CHEST & OVERHEAD
Remove top mat from roll cab. NOTE: If a rubber mat or
a stainless/wood top is on the unit, it must be removed
to access the mounting holes.
Lift top chest or overhead into place. NOTE: Two or more people
may be necessary for installation as these accessories are heavy.
Using the quick disconnect tabs on the top drawer slides,
remove top drawer(s) to access the mounting hardware locations.
Fasten units together at the two front and two rear locations using
the hardware provided.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
44
MOUNTING END CAB
NOTE: DO NOT MOUNT KRL1099 ON KRL7000 SERIES ROLL CABS.
PREPARING END CAB FOR RIGHT SIDE MOUNT
• If a handle is mounted on the right side of the roll cab, remove
the handle or consider installing the end cab on the left side
• Mounting the end cab may require more than one person
• To lighten unit and make mounting easier, remove all drawers.
Refer to Removing and Replacing Drawers in these instructions
MOUNTING END CAB ON RIGHT SIDE
1. Hang end cab on the right side of the roll cab and position
it so that the trim is flush to front
2. Using the pre-drilled mounting holes located at the bottom of the
side panel of the end cab as guides, drill (2) 7/32" (.219 diameter)
holes through the side panel of the roll cab
3. Insert (2) 3/16" plastic spacers between the end cab and roll cab.
Pass the two screws through the panel, spacers and roll cab side
panel. Secure unit together using the nuts
4. Replace the drawers and vertical panels. Refer to Removing
and Replacing Drawers in these instructions
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
MASTERS SERIES
MASTERS SERIES
PREPARING END CAB FOR LEFT SIDE MOUNT
• If a handle is mounted on the left side of the roll cab, remove
the handle or consider installing the end cab on the right side
IF MOUNTING A KRL715A, KRL1015A OR KRL7015A
STORAGE END CAB:
• Remove the door stop on the left side of the cabinet
by removing the screws
• Remove screws from the door hinge, rotate door 180º
and attach door on the left side of the end cab
• Re-install the door stop on the right side of the cabinet
IF MOUNTING A KRLV7015 VERTICAL STORAGE END CAB:
• Remove the vertical panels. See Figure 1. Refer to Removing
and Replacing Drawers in these instructions
• Slide out the top and bottom assembly and set aside making
sure to differentiate the top assembly from the bottom assembly
MOUNTING END CAB ON LEFT SIDE
1. Hang end cab on the left side of the roll cab and position
it so that the trim is flush to front
2. Using the pre-drilled mounting holes located at the bottom of the
end cab side panel as guides, drill (2) 7/32" (.219 diameter) holes
through the side panel of the roll cab
3. Insert (2) 3/16" plastic spacers between the end cab and roll cab.
Pass the two screws through the panel, spacers and roll cab side
panel. Secure unit together using the nuts
45
Publicidad
