Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLE MOUNTING INSTRUCTIONS
• Align handle holes with the holes in the side of the roll cab
• Insert screws through handle holes and tighten
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
50
ACCESSORY SET UP INSTRUCTIONS
TOP CHEST & OVERHEAD
Remove top mat from
roll cab. NOTE: If a rubber
mat or a stainless/wood
top is on the unit, it must
be removed to access
the mounting holes.
Lift top chest or
overhead into place.
NOTE: Two or more
people may be necessary
for installation as these
accessories are heavy.
Using the quick
disconnect tabs
on the top drawer
slides, remove top
drawer(s) to access
the mounting hardware
locations. Fasten units
together at the four hole
locations using the
hardware provided.
CLASSIC SERIES
LATCH & DRAWER TRIMS
To remove latches from drawer trim, start by lifting the edge of
the latch up slightly. Once lifted over the slot in the drawer front,
slide the latch out of the drawer front horizontally.
2
1
CLASSIC SERIES
To remove drawer trim, pull drawer part way out. Remove latch
as shown. Using a striking bar and hammer, lightly force the drawer
trim downwards. Once you're able to, peel the entire drawer trim
off of the drawer.
Once trim is removed, new trim can be slid on to drawer front
and crimped on every 4" using the crimping tool (SPP838).
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
51
Publicidad
