Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING LOCKER
NOTE: DO NOT MOUNT KRL LOCKER TO ANY KRL ROLL CAB
EXCEPT THOSE CALLED OUT IN THE CATALOG.
PREPARING LOCKER FOR LEFT SIDE MOUNT
• If a handle is mounted on the left side of the roll cab, remove
the handle or consider installing the locker on the right side
• Mounting the locker may require more than one person
• To lighten unit and make mounting easier, remove all drawers.
Refer to Removing and Replacing Drawers in these instructions
MOUNTING LOCKER ON LEFT SIDE
1. Hang locker on the left side of the roll cab and position it so that
the door's flange (door closed) is recessed about 1" from the front
of the roll cab's front trim. Align locker as required, so the front
mounting hole is centered on the handle mounting hole of the
roll cab
2. Insert the 1/4-20" x 5/8" screws through the front and rear
mounting holes of the locker, screw them into the roll cab's handle
mounting holes, and tighten until snug
3. Using the pre-drilled mounting holes located at the bottom of the
side panel of the locker as guides, drill (2) #24 (.152 diameter) holes
through the side panel of the roll cab
4. Use (2) #10-16 x 1/2" screws to secure
the bottom of the locker to the roll cab
5. Replace the drawers
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
46
PREPARING LOCKER FOR RIGHT SIDE MOUNT
• If a handle is mounted on the right side of the roll cab, remove
the handle or consider installing the locker on the left side
• Mounting the locker may require more than one person
1. Remove the round magnetic door catches from the right side of
the cabinet by depressing the plastic fingers behind the flange
that they are mounted to while pushing outward
2. Remove screws from the door hinge, rotate door 180º
and attach door on the other side of the locker
3. Re-insert the magnetic door catches into the holes
in the left flange of the cabinet
4. Remove and flip nameplate
MOUNTING LOCKER ON RIGHT SIDE
5. Hang locker on the right side of the roll cab and position it so that
the door's flange (door closed) is recessed about 1" from the front
of the roll cab's front trim. Align locker as required, so the front
mounting hole is centered on the roll cab's handle mounting hole
6. Insert the 1/4-20" x 5/8" screws through the locker's front and rear
mounting holes, screw them onto the roll cab's handle mounting
holes, and tighten until snug
7. Using the pre-drilled mounting holes located at the bottom of the
locker's side panel as guides, drill (2) #24 (.152 diameter) holes
through the side panel of the roll cab
8. Use (2) #10-16 x 1/2" screws to secure
bottom of the locker to the roll cab
9. Replace drawers removed in step 1
MASTERS SERIES
LATCH & DRAWER TRIMS
To remove latches from drawer trim, start by lifting the edge of the
latch up slightly. Once lifted over the slot in the drawer front, slide the
latch out of the drawer front horizontally.
2
1
MASTERS SERIES
To remove drawer trim, pull drawer part way out. Remove latch as
shown. Using a striking bar and hammer, lightly force the drawer
trim downwards. Once you're able to, peel the entire drawer trim
off of the drawer.
Once trim is removed, new trim can be slid on to drawer front
and crimped on every 4" using the crimping tool (SPP838).
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
47
Publicidad
