Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLE MOUNTING INSTRUCTIONS
3
2
1
32
• Align handle (3) with weld nuts in the side panel of the roll cab
• Insert screws (1) and lockwashers (2) through handle holes
and tighten
• Cover handle holes on opposite side of roll cab
with hole plugs, if desired
IMPORTANT
The handle and swivel casters must be mounted on the same side of
the roll cab in order to steer unit properly. If your roll cab has multiple
swivel casters with swivel locks, lock the casters on the opposite side
of the handle before moving the roll cab.
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
EPIQ SERIES
TRIM & TRIM CAP SERVICE INSTRUCTIONS
REMOVE TRIM CAP
Trim cap is snap fit into position. Pry up to remove.
REMOVE TRIM CHANNEL
Trim channel is adhered to unit with automotive grade body molding
adhesive-backed tape. Pry with gradual, steady pressure to remove.
EPIQ SERIES
REMOVE TAPE RESIDUE
Remaining tape may be removed by applying pressure with
thumb or finger and working tape off in a rolling manner.
REPLACE TRIM AND CAP
• Clean painted surface with 70%
isopropyl (rubbing) alcohol
• Remove tape backing
• Align trim channel top
with sheet metal flanges
(about 1/4" below top)
• Press trim firmly into place. Tape
is pressure sensitive and won't
bond without sufficient pressure
• Insert trim cap
NOTE: SEE SAFETY PRECAUTIONS ON PAGES 8-13
33
Publicidad
