3M PELTOR WS ALERT XP Manual Del Usuario página 10

2.2. CAUTION
• Risk of explosion if battery is replaced by an incorrect type.
• Do not charge batteries in temperatures above 45°C (113°F).
• Use only 3M™ PELTOR™ rechargeable batteries.
• Only use the 3M™ PELTOR™ Power Supply FR08 when
recharging the battery.
• Always use product-specific 3M replacement parts. Use of
unauthorized replacement parts may reduce the protection
you receive from this product.
2.3. NOTE
• When worn according to these User Instructions, this
hearing protector helps reduce exposure to both continuous
noises, such as industrial noises and noises from vehicles
and aircraft, as well as impulse noises, such as gunfire. It is
difficult to predict the required and/or actual hearing
protection obtained during exposure to impulse noises. For
gunfire, the weapon type, number of rounds fired, proper
selection, fit and use of hearing protection, proper care of
hearing protection, and other variables will impact
performance. To learn more about hearing protection for
impulse noise, visit www.3M.com.
• This hearing protector is provided with level-dependent
attenuation. The user should check correct operation before
use. If distortion or failure is detected, the user should refer
to the manufacturer's advice for maintenance and
replacement of the battery.
• This hearing protector is provided with safety-related audio
input. The user should check correct operation before use. If
distortion or failure is detected, the user should refer to the
manufacturer's advice for maintenance.
• This hearing protector limits the entertainment audio signal
to 82 dB (A) effective to the ear.
• Operating temperature range: –20°C (–4°F) to 50°C (122°F)
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• To properly dispose of the battery, follow local solid waste
disposal regulations.
• Only use AA non-rechargeable or 3M™ PELTOR™ Ni-MH
rechargeable LR6NM batteries.
• Do not charge alkaline batteries as this may cause damage
to the headset.
3. APPROVALS
3.1. EU AND GB APPROVALS
EU
Hereby, 3M Svenska AB declares that the radiobroadcast
reciever / Bluetooth is in compliance with Directive 2014/53/
®
EU and other appropriate directives to fulfill the requirements
for the CE marking.
3M Svenska AB also declares that the PPE type hearing
protector is in compliance with Regulation (EU) 2016/425.
The PPE is audited annually by SGS Fimko Ltd., Takomotie
8, FI-00380 Helsinki, Finland, Notified Body No. 0598, and
type approved by PZT GmbH, Notified Body No. 1974,
Bismarckstrasse 264 B, 26389 Wilhelmshaven, Germany.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020, EN 352-8:2020.
GB
Hereby, 3M Svenska AB declares that the Bluetooth
radio communication is in compliance with Radio Equipment
Regulations 2017 and other appropriate Regulations to fulfill
the requirements for the UKCA marking.
3M Svenska AB also declares that the PPE type hearing
protector is in compliance with Personal Protective Equipment
Regulations (Regulation 2016/425 as brought into UK law
and amended).
The PPE is audited annually, and type approved by SGS
United Kingdom Limited, Rossmore Business Park, Ellesmere
Port, Cheshire, CH65 3EN, UK, Approved Body No. 0120.
The product has been tested and approved in accordance
with EN 352-1:2020, EN 352-3:2020, EN 352-4:2020,
EN 352-6:2020, EN 352-8:2020.
EU and GB
The applicable legislation can be determined by reviewing the
Declaration of Conformity (DoC) at www.3M.com/peltor/doc.
The DoC will show if some other type-approvals are also
applicable. When retrieving your DoC, please locate your part
number. The part number of your earmuffs can be found at
the bottom of one cup. An example can be seen in the picture
below.
A copy of the DoC and additional information required in the
Regulations and Directives can also be obtained by
contacting 3M in the country of purchase. For contact
information, see last pages of this User Instruction.
This product contains electrical and electronic components
and must not be disposed of using standard refuse collection.
Please consult local directives for disposal of electrical and
electronic equipment.
** 3M™ PELTOR™ WS™ ALERT™ XPI Headset
0120
EN
and
®
13