Publicidad
Idiomas disponibles
Idiomas disponibles
Pando
Pando Wine Cellar
AUTOMATIC OPENING PUSH FUNCTION
For models only:
The PushOpen door function (if your model has one) is activated when the unit is switched on. To open the
door, push it inwards slightly to the top left position for the right hinged model (top right position for the left
hinged model) and then release it. The push piston will open the door slightly. The push piston opens the
door slightly. The door can then be fully opened manually. The push piston automatically returns to its initial
position after 2 seconds.
NOTE:
- To prevent unintentional opening, the door will close again after about 2 seconds if you do not pull it
manually on hinged models.
- Do not block the door or hold it while opening. If you block the door or hold it while opening, the
automatic door opening device and the door will be damaged. Loud and repeated clicking sounds will be
heard.
- Do not push the push piston or hold it during closing. If the push piston is blocked during closing, it will
no longer be able to reach its initial position. In the initial position, the push piston is flush with the front of
the enclosure. To return the push piston to its initial position, disconnect the appliance from the mains,
wait approximately 10 seconds and then switch it on again. The impulse piston returns to its initial position.
The impulse piston returns to its initial position.
- The system does not activate immediately after closing the door. Wait 3 seconds and try again. This is
not a system malfunction.
The door of the unit is pressure sensitive. The pressure sensitivity to open the door can be
adjusted as indicated below:
- Open the door.
- Turn the screw in the top centre of the door anti-clockwise to increase the sensitivity and clockwise to
decrease it.
- Close the door and check that the setting is correct. Turning the screw too far anti-clockwise may cause
the door to open automatically even without pushing or simply closing the door forcefully. Conversely,
turning the screw too far clockwise may cause the door not to open even with a strong push.
-
-
-
-
-
178
English
EN
Publicidad
