Pando PVMB 30-16CR Manual página 196

English
EN
The indoor fan motors are switched on and off even when the set temperature is
9.
reached.
To circulate the air and maintain the set temperature inside the cabinet, the indoor fans must
run ON and OFF when the compressor is off in Dynamic Climate mode. The fans will cycle
on and off approximately every 20 seconds. This cycle is normal and is done both to circulate
the air and to ensure the continuous running status of the fans. If the fan stops completely
and does not complete the cycle, the fan will not operate. The Dynamic Climate mode is the
factory preset mode. If the user finds it noisy, the SILENT mode can be selected by pressing
and holding the UP key for at least 5 seconds until hearing "B B B" three sounds confirming
that the silent mode is activated.
High and low temperatures cannot be set separately - both are set at the same time (if
10.
one is raised, the other is raised, etc.).
This is normal. The set temperature of the LOWER ZONE should always be the same or
higher than that of the UPPER ZONE. Thus, when the user adjusts the temperature of one of
the zones, if the above condition cannot be met, the set temperature of the second zone will be
automatically changed to meet the above condition.
The control panel does not seem to be working.
11.
The control panel of this equipment has an auto-lock feature that prevents tampering with the
temperature or power settings. This feature is automatically activated 2 minutes after the last
touch of a control panel key. To unlock the control panel, press and hold the UP and DOWN
keys for 5 seconds.
The fans run constantly, is this normal?
12.
To circulate the air and maintain the set temperature inside the cabinet, the indoor fans must
run ON and OFF when the compressor is off in Dynamic Climate mode . The fans will cycle
on and off approximately every 20 seconds. This cycle is normal and is done both to circulate
the air and to ensure the continuous running status of the fans. If the fan stops completely
and does not complete the cycle, the fan will not operate.
The digital display works. But the appliance does not cool.
13.
Check if the appliance is in "Eco Demo Mode". Press and hold the "UP", "DOWN" and
"LIGHT" buttons at the same time for at least 5 seconds to exit the Eco Demo Mode.
The digital display, light and sound do not work, but the appliance cools well . You can
14.
that the device is in "display OFF" mode
Ice accumulates on the lower rear side (compressor area) and may rub against the
15.
fan , causing the unit to malfunction.
Check if there is any other appliance that produces or is a source of heat, such as a freezer,
oven etc., at the bottom or adjacent to it, especially in integration models, THE VINOTECA
MUST NOT BE INSTALLED UNDER THESE CIRCUMSTANCES.
Pando
193
Pando Wine Cellar