Descargar Imprimir esta página

Pando PVMB 30-16CR Manual página 192

Ocultar thumbs Ver también para PVMB 30-16CR:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
EN
Many common problems can be easily solved, saving you the cost of service support
Try the following suggestions to see if you can solve the problem before calling customer service /
after sales.
PROBLEM
Nothing works.
The device
does not work.
The appliance
does not cool
sufficiently.
The appliance
switches on
and off
frequently.
The light does
not come on.
SOLUTION OF PROBLEMS
POSSIBLE CAUSE
• The device is not connected to a
power supply.
• The device is switched off.
• The circuit breaker has tripped or has
been tripped. blown fuse.
• Temperature is not set correctly.
• The ambient temperature may require a
different temperature setting.
• The door opened with too much
frequency.
• The door was not completely closed.
• The door is not hermetically sealed
closed.
• The condenser is too dirty.
• The ventilation opening is blocked
or too dusty.
• The ambient temperature is higher than
• A large number of bottles have
been added to the unit.
• The door opens with too much
frequency.
• The door does not close completely.
• Door seal does not seal
correctly.
• The device is not connected to a
power supply.
• The circuit breaker has tripped or has
been tripped blown fuse.
• The light went out on the control panel.
• Faulty light.
Pando
media.
189
Pando Wine Cellar
REMEDY
• Switch on the device.
• Switch on the device.
• Turn on the circuit
breaker or replace
the fuse.
• Check the temperature
programmed.
• Set another temperature.
• Do not open the door wider
than necessary.
• Close the door tightly.
• Check the door seal and
clean or replace it.
• Clean the condenser when
as necessary.
• Clear obstacles and clean up
the dust.
• Place the device in a location
cooler.
• Let the appliance operate for
a while until it reaches
the set temperature.
• Do not open the door wider
than necessary.
• Close the door tightly.
• Check the door seal and
clean or replace it.
• Switch on the device.
• Turn on the circuit breaker
or replace the fuse
• Turn on the light.
• Call a service technician for
replacement.

Publicidad

loading