CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso página 35

5.2 - REAR WHEEL ON THE FREEWHEEL SIDE
• Before proceeding with assembly, check in the technical specifications on page 3 the type and length of the spoke to be replaced, the recom-
mended value and the maximum value which must not be exceeded when tightening the spokes.
• Check that there are no residues of sand or any other foreign material inside the rim and, if necessary, remove them with a jet of compressed air.
• Obtain a new, original Campagnolo
• Always prevent the rotation of the spokes when nuts are tightened or loosened. Make sure that no damage is caused to the surface of the spokes.
CAUTION!
Take special care when handling the spokes during assembly to prevent accidentally scratching the rim.
• Remove the sprocket set (Section 2 of the "Owner's Manual -
PART 1).
• Slightly closed the spoke retainer ring and slide it out from the free-
wheel side (Fig. 22).
• Using a 5 mm hex wrench, completely unscrew the nut of the
spoke to be replaced, holding the latter steady to prevent rotation,
remove it, remove the plate and then slide the spoke out of the rim
(Fig. 23).
12
® replacement spoke.
22 23
5 mm