Hubs Adjustment - CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso

7. HUBS ADJUSTMENT

• Using a stiff blade (such as small knife) positioned as indicated in Fig. 29 (page 15) and taking care not to damage the hub or the spokes, remove
the side covers from the hub.
• Align the screw (A - Fig. 47) of the lock ring (B - Fig. 47) with the groove (C - Fig. 47) on the hub body.
• Fully insert the 2.5 mm Allen wrench (D - Fig. 48) into screw (A - Fig. 48) and tighten it by about three (3) turns.
• To reduce axle clearance, tighten lockring (B - Fig. 48) by turning it clockwise by hand or with a 21 mm wrench.
• To increase axle clearance, loosen lockring (B - Fig. 48) by turning it counter-clockwise by hand or with a 21 mm wrench.
Strike screw (E - Fig. 49) lightly with the plastic handle of the Allen wrench.
• Tighten the Allen screw (A - Fig. 48) with the wrench properly seated on it until the gap (X - Fig. 48) on the lockring (B - Fig. 48) is completely
closed.
• Make sure that the adjustment is correct (the axle slides easily and without play), otherwise repeat the adjustment procedure.
47
A
B
C
48
A
B
X
OPEN
CLOSE
OPEN
49
CLOSE
D
E
21