CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso página 39

• Unscrew and remove the lock ring (C - Fig. 33), press the axle (G
- Fig. 33) towards the hub body, remove the ring (F - Fig. 33), the
cone (H - Fig. 33), slide out the axle (G - Fig. 33) from the hub,
remove the cone (I - Fig. 33), the gaskets (J - Fig. 33) taking care
not to damage them and the ball bearings (K - Fig. 33).
• If it is necessary to replace the cups, contact a Campagnolo
Service Center.
• Proceed to refit the system performing disassembly operations in
reverse order.
Attention
When inserting the axle, be careful not to move the ball bearings out
of their seats.
• Tighten the locking nut (B - Fig. 34) to a torque setting of 12 N.m
- 8.8 lb.ft.
• Adjust the hub as illustrated in section 7.
16
33
C F J H K
®
34
B
12 N.m - 8.8 lb.ft
K J I G