Brakes - CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso

8. BRAKES

WARNING!
Use only the special brake pads part number BR-RE701 with the composite BORA 2003
tubular rims. do not use these pads with any other brake pads-rim combination could results
in insufficient and/or irregular braking performance, thereby causing an accident, personal
injury or death.
Use of any other brake pads-rim combination could also seriously damage the rim.
Always check that the brake pad is compatible with the rim by checking the specifications on
the brake pad blister package.
Attention
Also consult the section "Brakes" of the "Owner's Manual - Part 1.
• Slide out the brake pads from the pad holders and replace them with those supplied in the wheel
package.
• Adjust the brake pads so that they are perfectly
aligned with the wheel braking surface, about 1 mm
from the surface of the rim (Fig. 50) so that they are
positioned at about 1~2 mm from the top edge of the
rim (Fig. 51) (refer to the brake pad instruction
sheet).
• Before every ride:
- make sure that the brakes function correctly.
- make sure that the cables and brake pads are in
good condition.
- make sure that the brake pads are perfectly aligned
with the wheel braking surface, about 1 mm from the
surface of the rim (Fig. 50) so that they are posi-
tioned at about 1~2 mm from the top edge of the rim
(Fig.51) (refer to the brake pad instruction sheet).
22
51
TUBULAR
RIM
BRAKE PADS
50
~1 mm ~1 mm