CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso página 42

• Position the freewheel close to the hub and hold it pressed against
the latter; lower one by one the three pawls with an Allen wrench
or a screwdriver and insert freewheel fully into its seat (Fig. 40).
• Tighten the locking nut (E - Fig. 41) with a 17 mm wrench, holding
the axle steady from the freewheel side with a snugly fitted 5 mm
Allen wrench (approximate torque setting: 15 N.m - 11 lb.ft).
• Adjust the hub as illustrated in section 7.
Note
The BORA freehub is not compatible with sprocket sets with last
position sprocket (near the flange) lower than 21 teeth.
40
41
E
CLOSE
15 N.m - 11lb.ft
19