Publicidad
Idiomas disponibles
Idiomas disponibles
Check mower safety start interlock system daily prior
to operation. This system is an important mower
safety feature. It should be repaired immediately if
it malfunctions. The mower incorporates a separate
operator presence control switch which will stop the
drive system and blade motors when the operator is not
in place for any reason while the mower is operating.
This is a safety feature designed to prevent runaway or
accidental entanglement.
WARNING
The safety interlock system must not be disconnected
or bypassed. Doing so could cause the product to
operate unexpectedly, resulting in personal injury.
3
UNCRATE THE PRODUCT
The mower is shipped in a crate. Here is the procedure to uncrate it and drive it out.
1. Remove two pins, washers and clevis pins securing the wire netting to the frame and remove the wire netting.
2. Remove each pin, washer and clevis pin securing every brace to the frame and remove the braces.
3. Release or cut the four straps securing the front and rear wheel axles to the bottom frame.
4. Remove boxes containing the loose parts, assembly hardware and documentation.
English
To inspect the system:
1. The operator must be on the seat when testing the
operator presence control switch.
2. Insert the start key and turn to ON position.
3. Make sure the steering control levers are pivoted
outwards to engage the parking brake.
4. Pull the PTO switch to engage the blade motor.
5. Slowly stand up from the seat. The mower blades
should stop in 3 seconds.
6. If the mower blades fail to stop when the operator
is not in place, contact your authorized servicing
dealer immediately. Do not operate the mower until
the safety start interlock system has been repaired.
11
EN
Publicidad
