GreenWorks MZ546 Manual Del Operador página 41

16.2 LEFT WHEEL MOTOR CONTROLLER ERROR CODES
Error Co- Error Contents
des
TL 2 Drive motor stalled
TL 5 Motor encoder error
TL 6 Controller phase loss
TL 7 MOSFET error
TL 8 Controller undervoltage
TL 9 Controller overvoltage
TL 12 Motor overtemperature
TL 13 Controller overtemperature
TL 14 Overcurrent-Level 1
TL 15 Overcurrent-Level 2
TL 16 Speed throttle error
TL 19 Operating sequence error
TL 21 ETO relay error
TL 22 Magnetic valve error
TL 23 Battery compartment
(PMU)communication error
TL 24 Battery compartment (PMU)
error
TL 25 CAN timeout error - left drive
TL 26 CAN timeout error - right
drive
TL 27 CAN timeout error - left blade Communication failure with the left blade controller. Restart the power
English
Suggestions
Check if the drive wheels are stuck and restart the power supply.
Check that the connector of motor is properly connected with the drive
controller, and then restart the power supply.
Check that motor cables of the drive controller are connected properly,
and then restart the power supply.
If you encounter this issue, contact your distributor for a solution.
The voltage is too low. Charge the battery pack before use.
The voltage is too high. Restart the power supply.
The motor temperature is too high. Wait for the motor to cool down, and
then restart the power supply.
The controller temperature is too high. Wait for the controller to cool
down, and then restart the power supply
The load is too high. Restart the power supply.
The load is too high. Restart the power supply.
Check that the speed controller of handle is connected properly, and
then restart the power supply.
Place the left and right levers in the park position and try again.
Restart the power supply.
Check that the solenoid valve of drive motor is connected properly, and
then restart the power supply.
Communication failure with battery compartment. Restart the power
supply.
Minor/major error in battery compartment. Perform a check and restart
the power supply.
Communication failure with the left drive controller. Restart the power
supply.
Communication failure with the right drive controller. Restart the power
supply.
supply.
41
EN