Publicidad
Idiomas disponibles
Idiomas disponibles
EN
It is equipped with a tipping mechanism for unloading
materials.
When driving on the slope, the maximum load
capacity of the rear storage bin is lbs.
1. Move the release lever forward to disengage the
rear storage bin.
2. The rear storage bin will tip backward.
3. To return the storage bin to its original position,
push the release lever forward, then push the rear
storage bin forward until it securely locks onto the
release lever hook.
6
ELECTRICAL SYSTEM
6.1
ELECTRICAL SYSTEM SAFETY
To reduce the risk of serious personal injury from fire or
electric shock when working on the electrical system:
•
Always remove the start key and batteries, and read
operator manual before working on this product.
•
Always remove the start key and batteries when
transporting the product.
•
Keep the product free of grass clippings, leaves
and other debris. DO NOT use water to clean the
product. Use only compressed air. Wear adequate
eye and hearing protection when cleaning the
product.
•
Always wear protective gear (safety glasses, face
shield and gloves) when working with the battery.
Use insulated tools.
WARNING
English
•
Clean the product of all dirt and debris. Do not use
solvents, hard cleaners or abrasives.
•
Keep the area clear of bystanders when engaging
the PTO switch.
•
Never allow flames, sparks or smoking near the
product or batteries.
•
Keep the product and batteries out of reach of
children.
•
Always keep protective shields, covers and guards
in place and securely fastened. If they become
damaged, repair or replace immediately. Never
modify or remove safety devices.
6.2
ELECTRICAL SYSTEM
INFORMATION
The product is powered by a 60V / 80V electrical
system. It consists of the following components:
1. Blade controller (1)
2. Blade motor (3)
3. Drive controller (2)
4. Accelerator - right (1)
5. Accelerator - left (1)
6. Digital display (1)
7. Wheel motor (2)
8. Battery (6)
9. Front light (2)
10. Front fender light (2)
11. Rear light (2)
12. ROPS light (1)
13. ETO socket (1)
7
OPERATION
This section describes how to operate the product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
7.1
BEFORE OPERATION
7.1.1 CONNECT THE BATTERIES TO THE
PRODUCT
Only use genuine Greenworks batteries with the
product.
1. Make sure that the batteries are fully charged.
2. Press the release button to open the small battery
compartment cover.
18
WARNING
WARNING
Publicidad
