Publicidad
Idiomas disponibles
Idiomas disponibles
Move the wheels up or down - using the different axle
mount holes in the wheel mount bracket (if applicable
on model).
1. After adjusting the cutting height, adjust the anti-
scalp wheels by removing the locking flange nut, the
hex bolt which fix the wheels.
2. Select a hole so that the wheel is positioned to the
corresponding height-of-cut desired.
Note: For cutting height over 4.5 inches (114 mm)
use the bottom hole. The anti-scalp wheels will be
effective against scalping.
3. Install the locking flange nut and the hex nut.
4. Repeat the adjustment on the other anti-scalp
wheels.
5.1.5 FOOT PEDAL & DECK HEIGHT
ADJUSTMENT PIN
Before using the mower, raise the deck height to the
cutting position best suited for your lawn.
When transporting the mower, adjust the deck height to
5.5'' (139.7 cm) by stepping on the foot pedal to the end
and lock.
Cutting height is adjustable from 1.5-4.5 inch. Deck
should be raised to avoid stumps, rocks or other
obstacle that might damage mower deck.
To adjust the cutting height:
1. Stop the mower and disengage blades.
2. Turn the start key to OFF position and set the
parking brake.
3. Step on the foot pedal (2) and push forward till the
very end.
4. Choose a desired deck height, insert the height
adjustment pin (1) into slot to secure.
5. Slowly release the foot pedal.
English
1.5-2.5 in
2.5-3.5 in
3.5-4.5 in
1
2
17
5.1.6 CONTROL PANEL
2
1
9
8
Note: Adjustments for blade speed, drive speed, and
lights are only possible on the home screen.
1. Blade Speed / Back Button: Adjust the blade speed
(cyclic). / Return to previous page.
2. Menu / Page Up Button: Menu / Navigate page up.
3. Digital Display Screen: This digital display screen
shows important electrical system information. See
Digital Display Screen under Operation.
4. Lights / Page Down Button: Activate lights /
Navigate page down.
5. Drive Speed / Confirm Button: Adjust the drive
speed (cyclic). / Press to confirm.
6. USB Charging Port: Open the top cover to access
the USB-A and USB-C charging ports. The mower must
be activated for charging.
CAUTION
Attempting to charge devices rated more than 2.1
amps could damage the USB charging port and/or the
mower.
7. Phone Slot: Mobile device storage.
8. Ignition Switch: This switch is used to turn the
mower on and off. The start key must be inserted before
the switch can be operated.
9. PTO (Power Take Off) Switch: The PTO switch
engages and disengages the mower blades. Pull UP on
the switch to engage, and push DOWN to disengage.
CAUTION
Do not engage PTO switch when the deck is under
load. Failure to do so may damage the motor and/or
deck.
5.1.7 REAR STORAGE BIN
The mower's rear storage bin can transport various
tools or materials, with a maximum load capacity of lbs.
3
4
5
6
7
EN
Publicidad
