Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Install a bolt through each rotation shaft and tighten
securely with a T30 wrench, applying torque within
the range of 3 - 4 ft-lbs (4 - 6 N·m).
3. Install the bolts and nuts to secure the top of the
rear storage bin. Ensure that the nuts are positioned
outside the storage bin. Use a 10 mm wrench
applying torque within the range of 2 - 3 ft-lbs (3
- 4 N·m).
4. Securely suspend the tailgate cable on the bolts
ensuring that the metal sheet sides face outward.
4.4
INSTALL THE STEERING
CONTROL LEVER
The two levers control the mower's speed, direction,
stopping, neutral lock, and parking brake, serving to
steer, adjust speed, reduce speed, stop, and change
direction.
English
2
1
14
WARNING
The left and right steering levers should be adjusted
so that they align and mirror each other when in the
neutral position. NEVER install the steering levers in
an asymmetrical operating height.
1. Lift the steering control lever to align the holes in the
lever with the holes in the mounting pole.
2. Select the preferred steering-lever operating height.
Insert the screw together with the washer into the
hole. Secure the screw as close to the center of the
hole as possible to ensure proper alignment.
3. Use a 16mm wrench to tighten the steering control
lever bolts, applying torque within the range of 14 -
22 ft-lbs (20 - 30 N.m).
4. Fasten the rubber cover of each lever by tightening
three screws with a T30 wrench and applying torque
within the range of 4 - 6 ft-lbs (5 - 8 N.m).
5. After installing both rubber covers, ensure that both
handles mirror each other and automatically align
after being pulled backwards.
Publicidad
