Publicidad
Idiomas disponibles
Idiomas disponibles
8.3
NEUTRAL BYPASS LEVER
The neutral bypass levers disengage the drive system
that connects the engine power to the wheels and may
be used when you need to manually push or move the
mower without the engine running.
•
Locate the neutral bypass levers situated
underneath the rear of the mower's frame. These
levers individually manage the drive wheels.
•
Push the lever outwards to unlock the levers to
release the drive brakes.
•
Push the lever inward to lock the levers for regular
operation.
WARNING
Never drive mower with the neutral bypass lever
disengaged. Always engage the neutral bypass lever
to the original position before driving! Failure to
engage the lever could cause serious damage to your
mower and void mower warranty!
English
Never unlock the neutral bypass levers when the
mower is on a slope. Once the levers are released,
the mower can roll freely and does not have a brake.
Releasing the lever on a slope could lead to loss of
control and increase the risk of serious personal injury.
8.4
MOVE THE MOWER MANUALLY
To push the mower manually:
1. Disengage the blades and push the steering control
levers outward to engage the parking brake.
2. Turn the start key to the OFF position. Remove the
start key, and wait for all moving parts to stop before
leaving the operating position.
3. Return the steering control levers to the NEUTRAL
position then unlock the neutral bypass levers to
disengage the drive system.
4. Move the mower to the desired location.
To avoid damage to the motor and drive system,
do not move the product faster than 5 mph (8
km/h).
5. Immediately after moving the mower, lock the
neutral bypass levers.
9
CLEAN AND STORAGE
9.1
CLEAN THE PRODUCT
•
Remove any build-up of grass and leaves on or
around the motor cover (Do not use water).
•
Occasionally wipe the mower clean with a dry cloth.
•
If debris builds up on the underside of the mower
during use, stop the motor on level ground,
disengage the PTO switch, set the parking brake,
shut off the product, remove the start key and use
the compressed air to clean the area.
9.2
STORE THE PRODUCT
The following steps should be taken in order to prepare
the product for storage.
•
Clean the Mower: Before storing the product,
thoroughly clean it as outlined in the previous
section.
•
Blade Inspection and Maintenance: Inspect the
blades and replace them as detailed in the Service
the Mower Blades (Reference ) section if needed.
•
Avoid Corrosive Materials: Keep the mower away
from corrosive substances, such as fertilizer or rock
salt, as these can lead to rust and corrosion on
metal components like the blade, deck, motor, and
frame. Keep the mower and its battery away from
conductive or corrosive materials to reduce the risk
27
WARNING
CAUTION
EN
Publicidad
