Publicidad
Idiomas disponibles
Idiomas disponibles
3.6 BRAKE (Electronic Parking Brake Reset)
This function helps you to replace and reset the brake pads.
Use cases:
The brake pads and brake pad wear sensor are replaced.
•
•
The brake pads indicator lamp is on.
The brake pads sensor circuit is short, which is recovered.
•
•
The servo motor is replaced.
3.7 DPF (DPF Regeneration)
This function can help remove particulate matter from the trap by using combustion
oxidation methods to keep the trap performance stable.
Use cases:
•
The exhaust back pressure sensor is replaced.
•
Disassembly or replacement of the particle trap.
Removal or replacement of fuel additive nozzles.
•
•
Removal or replacement of catalytic oxidizer.
The DPF regeneration fault lamp remains lit and matched after maintenance.
•
•
The DPF regeneration control module is repaired or replaced.
3.8 GEAR (Tooth Learning)
This function can perform tooth learning for the car to turn off the MIL.
Use cases:
•
After the engine ECU, the crankshaft position sensor or crankshaft flywheel is replaced.
•
There is a DTC of 'tooth not learned.'
3.9 IMMO (Anti-theft Matching)
This function can match the anti-theft key after replacing the ignition key, ignition
switch, instrument cluster, engine control unit (ECU), body control module (BCM), and
remote control battery.
3.10 INJEC (Injector Coding)
This function can write actual injector code or rewrite code in the ECU for the injector
code of the corresponding cylinder to more accurately control or correct cylinder
injection quantity.
It needs to be performed after the ECU or injector is replaced.
3.11 TPMS (Tire Pressure Reset)
This function can reset the tire pressure and turn off the tire pressure fault indicator
when the car tire pressure fault indicator light is on.
EN I 25
Publicidad
