Descargar Imprimir esta página

TOPDON Phoenix Lite 3 Manual Del Usuario página 29

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
3.20 A/F (A/F Reset)
This function can set or learn Air/Fuel ratio parameters.
3.21 STOP/START (Stop/Start Reset)
This function can open or close the automatic start-stop function by setting the
hidden function in ECU (provided that the vehicle has a corresponding hidden function
supported by hardware).
3.22 NOX (NOx Sensor Reset)
This function can reset the catalytic converter learned value stored in the engine ECU.
It needs to be performed when the NOx fault is re-initialized and the NOx catalytic
converter is replaced.
3.23 ADBLUE (Diesel Engine Exhaust Gas Filter)
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset
operation is required.
3.24 SEATS (Seat Calibration)
This function can match the seats that are replaced and repaired with memory function.
3.25 COOLANT (Coolant Bleeding)
This function can activate the electronic water pump before venting the cooling system.
3.26 TYRE (Tire Reset)
This function can set the size parameters of the modified or replaced tire.
3.27 WINDOWS (Windows Calibration)
This feature can perform door window matching to recover ECU initial memory and
recover the automatic ascending and descending function of power window.
3.28 LANGUAGE (Language Change)
This function can change the system language of the vehicle central control panel.
3.29 CLUTCH MATCHING
This function can change the clutch pedal position or switch learning. After ECU
replacement, gearbox replacement/removal, or clutch replacement, this function learns
the contacts and positions where the clutch starts to transmit engine torque. Suitable
for adaptive clutches. Confirm the behavior of the clutch corresponding to the position
where the accelerator is lightly depressed when the vehicle is started. If smooth, the
contact point is correct. If the engine revs too high when the clutch starts to deliver
engine torque, or if there is a hard jerk, the contact point is incorrect. This condition
requires operation of the clutch matching function.
EN I 27

Publicidad

loading