Gear Oil Replacement - TOHATSU M 6B Manual Del Propietário

ENOM00098-A

Gear oil replacement

ENOW00094-0
WARNING
Be sure that outboard motor is secured
to transom or service stand, or acciden-
tal drop or fall of outboard motor could
lead to severe personal injury.
Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
Do not go under outboard motor tilted
up and locked, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
ENON00934-0
Note
Please dispose of used oil in a manner that
is compatible with the environment.
We suggest you take it in a sealed container
to your local service station for reclamation.
Do not throw it in the trash, pour it on the
ground or down a drain.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the lower
oil plug hole, and fill with gear oil by
squeezing the oil tube until oil flows out
of the upper plug hole and bubbles is
disappeared to remove the air.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 320 mL (10.8
fl.Oz).
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
ENOF01424-0
INSPECTION AND MAINTENANCE
CAUTION
53
ENOF01430-0
10