Publicidad
POWR
RECOIL STARTER
NOTE:
• Set the sheave drum so that the cut in
the sheave drum is diametrically oppo-
site the starter handle-grip.
• Pass the rope through the starter han-
dle-grip, and make a knot in the end of
the rope as shown.
• After assembling, wind the rope 3 turns
counterclockwise around the sheave
drum to contract the spring.
• By pulling out the rope, check the oper-
ation of the starter.
INSTALLING THE RECOIL STARTER
Install:
•
Recoil starter
•
Starter stop wire
Refer to the "ADJUSTING THE START -
IN-GEAR PROTECTION DEVICE" on
page 3-18.
5-9
E
1
2
Publicidad
Capítulos
