Overall Dimensions - SICE S 45 Manual De Instrucciones

ENGLISH • Instructions manual
2) Open the bead loosener arm (4, Fig. P) manually and depress the bead
loosener pedal (3, Fig. P): the bead loosener will close.
3) Depress the pedal all the way down (5, Fig. P): the four clamps (6,
Fig. P) on the table top will open. When the pedal is depressed again, the
clamps should close.
4) Depress the pedal (7, Fig. P) to bring the horizontal arm (11, Fig. P)
to its "non-working" position.
Depress the pedal again to bring the horizontal arm to its "working" posi-
tion again.
5) Press the yellow pushbutton (1, Fig. Q/1): the vertical slide (10, Fig. P) descends, facilitating the positioning of the toolhead against
the rim flange.
Press the red pushbutton (2, Fig. Q/1); the operating arms are locked simultaneously, and the toolhead automatically moves away 2 mm from
the rim flange (see chapter on demounting).
Press the toggle switch (3, Fig. Q/1); all the operating arms are unlocked simultaneously and the
vertical slide is raised (10, Fig. P).
6) Check that a drop of oil drops into the lubricator glass cup (12, Fig. P) after every two or three
movements of the footpedals (3 or 5, Fig. P).
Oil feed may be regulated by means of the Lubricator adjusting screw (see Fig. Q/2).
For S 45 GP version:
Activate the inflation pedal (Fig. Q/3) in position 1: air must flow out of the inflation head;
activate the inflation pedal (Fig. Q/3) in position 2: a powerful jet of air must flow out through the
holes in the four locking slides.
WARNING!
While performing this test, avoid holding your head above the
table top.
Dirt that may be present on the table top could strike the eyes
of the person working on it.
Take care you do not accidentally press the inflation pedal during
the various operating phases.
CORRECT WORK POSITION
In fig. Q/ 4 are the positions occupied by the operator during the various work phases:
A bead breaking
B Demounting and mounting
C Inflating area.

OVERALL DIMENSIONS

1
2
43
3
Q/1
Q/3
C
Q/2
A
B
Q/4
S 45