Assembly And Installation - Yamaha WR400F 1999 Manual De Servicio

FRONT FORK
EC554700
Cap bolt
1. Inspect:
Cap bolt 1
O-ring 2
Air bleed screw 3
Wear/damage → Replace.
EC555000

ASSEMBLY AND INSTALLATION

EC5551A0
Front fork assembly
1. Wash the all parts in a clean solvent.
2. Install:
Damper rod 1
To inner tube 2.
CAUTION:
To install the damper rod into the inner
tube, hold the inner tube aslant. If the inner
tube is held vertically, the damper rod may
fall into it, damaging the valve inside.
3. Install:
Copper washer 1
O-ring 2
Base valve 3
To inner tube 4 .
4. Tighten:
Base valve 1
NOTE:
Use a damper rod holder 2 to lock the
damper rod 3 .
Apply the LOCTITE
thread.
Damper rod holder:
YM-1423/90890-01423
5 - 32
CHAS
New
55 Nm (5.5 m · kg, 40 ft · lb)
®
on the base valve