DAB E.sybox Instrucciones Para La Instalación Y El Mantenimiento página 73

2.2.1 Hydraulic connections
Make the connection at input to the system through the mouth on Face C
marked "IN" in Fig.10 (suction connection). Then remove the respective cap
with the aid of the accessory tool or with a screwdriver.
Make the connection at output from the system through the mouth on Face C
marked "OUT 1" in Fig.10 and/or through the mouth on Face D marked "OUT
2" in Fig.10 (delivery connection). In this configuration either of the 2 mouths
can be used as an alternative to the other (depending on the convenience
of the installation), or simultaneously (dual delivery system). So remove the
cap(s) from the door(s) you intend to use with the aid of the accessory tool or
with a screwdriver.
All the hydraulic connections of the system to the plant to which it can be con-
nected are of the threaded female type 1" GAS, made of brass.
See WARNING for Figure 9.
2.2.2 Orientation of the Interface Panel
The Interface Panel has been designed so that it can be oriented in
the direction where it is most convenient for the user to read: its square
shape allows it to be rotated from 90° to 90° (Fig.11).
• Disengage the 4 screws at the corners of the panel using the
hex wrench provided with the accessory tool.
• Do not remove the screws, just disengage them from the thread
on the product body.
• Be careful not to drop the screws into the system
• Move the panel away, taking care not to pull on the signal
transmission cable
• Reposition the panel in its seat at the preferred angle taking
care not to pinch the cable.
• Tighten the 4 screws with the wrench
GB
ENGLISH
Figure 11
73