DAB E.sybox Instrucciones Para La Instalación Y El Mantenimiento página 87

The other menu pages vary with the associated functions and are
described later by type of indication or setting. Once you have entered
any menu, the bottom of the page always shows a summary of the main
operating parameters (running status or any fault, current speed and
pressure).
This allows a constant view of the machine's fundamental parameters.
Figure 16: Display of a menu parameter
Indications on the status bar at the bottom of each page
Identifying code
GO
SB
Disable
rpm
bar
Presence of an error preventing operation of the electropump
FAULT
Table 11: Indications on the status bar
The following may appear on the pages that show parameters: numerical
values and units of measure of the current item, values of other parameters
linked to the setting of the current item, graphic bar, lists; see Figure 16.
Description
Motor stopped
Motor stopped
Motor status manually disabled
Motor revs per minute
Plant pressure
6.4 - Blocking parameter setting by Password
The device has a password-enabled protection system. If a password is
set, the parameters of the device will be accessible and visible but it will
not be possible to change them.
The password management system is in the "technical assistance" menu
and is managed by means of the parameter PW
6.5 - Enabling and disabling the motor
In normal operating conditions, pressing and then releasing both the "+"
and "-" keys causes the blocking/release of the motor (self-holding even
after switching off). If there is a fault alarm, the operation described above
resets the alarm.
When the motor is disabled this status is shown by the blinking white
LED.
This command can be activated from any menu page except RF and PW.
7 - MEANING OF THE INDIVIDUAL PARAMETERS
7.1 - User Menu
From the main menu, pressing the MODE key (or using the selection
menu and pressing + o - ), gives access to the USER MENU. In the menu
the MODE key allows you to scroll through the various menu pages. The
values shown are the following.
7.1.1 - Status:
Displays the pump status.
7.1.2 - RS: Rotation speed display
Motor rotation speed in rpm.
7.1.3 - VP: Pressure display
Plant pressure measured in [bar] or [psi] depending on the measuring
system used.
7.1.4 - VF: Flow display
Displays the instantaneous flow in [litres/min] or [gal/min] depending on
the set measuring system.
GB
ENGLISH
87