Mettler Toledo IND131 Guia De Instalacion página 47

The summing board can then be placed on the bottom of the enclosure for wiring.
Prepare the ends of each of the load cell cables as shown in Figure 2-40 and Table 2-6. Make sure
the shield is connected to the gland as depicted in Figure 2-28.
Insert the load cell cables into the correct gland as identified in Figure 2-40
2-24 METTLER TOLEDO IND131/IND131x/IND331/IND331xx Installation Manual
Figure 2-37: Removing the Summing Board
A
Figure 2-38: Load Cell Cable Preparation
Table 2-5: Load Cell Cable Length
Cable Shield Length (A)
Load Cell 1 25mm (1 in.)
Load Cell 2 25mm (1 in.)
Load Cell 3 25mm (1 in.)
Load Cell 4 25mm (1 in.)
B
Stripped Cable Length (B)
127mm (5.0 in.)
127mm (5.0 in.)
190mm (7.5 in.)
190mm (7.5 in.)
Wire tie for load
cell cable harness
64067480 | 11 | 05/2018