Harsh Enclosure Wall Mounting - Mettler Toledo IND131 Guia De Instalacion

2.2.6.2.

Harsh Enclosure Wall Mounting

There is an optional wall mounting bracket kit available for wall mounting the harsh enclosure to a
vertical surface. To wall mount the enclosure, follow these steps:
1. Bolt the two brackets to the bottom of the enclosure using the four M5 screws included with the
2. If the enclosure will be mounted above eye level, proceed to step 4.
3. If the enclosure will be mounted at or below eye level, it will be necessary to reverse the front
2-12 METTLER TOLEDO IND131/IND131x/IND331/IND331xx Installation Manual
terminal. The brackets should be attached as shown in Figure 2-20.
Figure 2-20: Attaching the Wall-Mounting Brackets
cover 180 degrees. To reverse the front cover, perform the following steps:
A. Open the enclosure per the instructions provided in the Opening the Enclosures section.
B. Loosen and remove the two nuts securing the two grounding straps (that also operate as
hinges for the front cover) to the rear housing. See Figure 2-21.
Figure 2-19: IND331 Rubber Feet
64067480 | 11 | 05/2018