Installation - Mettler Toledo IND131 Guia De Instalacion

2.

Installation

This chapter covers
•
Opening the Enclosures
•
Mounting the Terminals
•
Installing Cables and
Connectors
•
Main Board Wiring Connections
•
PCB Switch Settings
•
Capacity Label Instructions
64067480 | 11 | 05/2018
This chapter provides installation instructions for the IND131 and IND331
terminals. Please read this chapter thoroughly before beginning installation.
DIV 2 AND ZONE 2/22 INSTALLATION
IF YOU WISH TO INSTALL THE IND131xx OR IND331xx TERMINAL INTO A DIVISION 2 OR
ZONE 2/22 AREA, REFER TO THE DIVISION 2 AND ZONE 2/22 INSTALLATION INSTRUCTIONS
INCLUDED ON THE DOCUMENTATION CD PROVIDED WITH THE TERMINAL. FAILURE TO
COMPLY WITH THE INSTRUCTIONS PROVIDED THERE COULD RESULT IN BODILY HARM
AND/OR PROPERTY DAMAGE.
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE
THE AREA IN WHICH THE TERMINAL IS LOCATED HAS BEEN SECURED AS NON-HAZARDOUS
BY PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE PERSON AT THE CUSTOMER'S
SITE.
IND131xx AND IND331xx TERMINALS USED IN A DIVISION 2 OR ZONE 2/22 ENVIRONMENT
MUST BE INSTALLED AND MAINTAINED PER THE SPECIAL CONDITIONS LISTED IN CHAPTER 2
OF THE DIVISION 2 AND ZONE 2/22 INSTALLATION MANUAL INCLUDED ON THE RESOURCE
CD WITHOUT EXCEPTION. FAILURE TO DO SO COULD RESULT IN BODILY HARM AND/OR
PROPERTY DAMAGE.
METTLER TOLEDO ASSUMES NO RESPONSIBILITY FOR CORRECT INSTALLATION OF THIS
EQUIPMENT WITHIN A DIVISION 2 OR ZONE 2/22 AREA. THE INSTALLER MUST BE FAMILIAR
WITH ALL DIVISION 2 OR ZONE 2/22 WIRING AND INSTALLATION REQUIREMENTS.
METTLER TOLEDO IND131/IND131x/IND331/IND331xx Installation Manual
WARNING
WARNING
WARNING
2-1