Identification; Type Plate; Applications; Appropriate, Acceptable And Correct Usage - Grundfos 384-511 Instrucciones De Instalación Y Funcionamiento

3. Identification

3.1 Type plate

384-513-10001
1
S/N: 10/035057
96622761P1108380891923
2
3
Fig. 1 Type plate, servomotor 384
Item Description
1 Model
2 Product number
3 Country of origin
4 Year and week code (YYWW)
5 Marks of approval, CE mark, etc.
6 Serial number

4. Applications

4.1 Appropriate, acceptable and correct
usage
Servomotors from Grundfos, series 384, are
intended for automatically setting the stroke length
and, thus, the dosing flow of Grundfos DMX and
DMH series dosing pumps, as described in these
instructions.
Warning
Only use the servomotor for the specified
pump types!
No other applications are approved or
Caution
permitted. Grundfos is not liable for
damage resulting from incorrect use.
6
4 5

5. Safety

This manual contains general instructions that must
be observed during installation, operation and
maintenance of the servomotor. This manual must
therefore be read by the installation engineer and the
relevant qualified personnel/operators prior to
installation and start-up, and must be available at the
installation location of the servomotor at all times.
It is not only the general safety instructions given in
this "Safety" section that must be observed, but also
all the specific safety instructions given in other
sections.
Information provided directly on the servomotor must
be observed and must be maintained in a readable
condition at all times.

5.1 Qualification and training of personnel

The personnel responsible for the operation,
maintenance, inspection and installation must be
appropriately qualified for these tasks. Areas of
responsibility, levels of authority and the supervision
of the personnel must be precisely defined by the
operator.
If the personnel do not have the necessary
knowledge, the necessary training and instruction
must be given. If necessary, training can be
performed by the manufacturer/supplier at the
request of the operator of the servomotor. It is the
responsibility of the operator to make sure that the
contents of this manual are understood by the
personnel.
5.2 Risks when safety instructions are not
observed
Non-observance of the safety instructions may have
dangerous consequences for the personnel, the
environment and the device. If the safety instructions
are not observed, all rights to claims for damages
may be lost.
Non-observance of the safety instructions may lead
to the following hazards:
• failure of important functions of the pump/system
• failure of specified methods for maintenance
• harm to humans from exposure to electrical,
mechanical and chemical influences
• damage to the environment from leakage of
harmful substances.

5.3 Safety-conscious working

The safety instructions in this manual, applicable
national health and safety regulations and any
operator internal working, operating and safety
regulations must be observed.
5