Intended Use; Description; Scope Of Delivery; Technical Design - SATA spray master RP Instrucciones De Servicio

Operating Instructions SATA spray master RP
General
■ Never point the spray gun at human beings.
■ Comply with the local regulations for safety, accident prevention, occu-
pational health and safety and environmental protection.
■ Heed the accident prevention regulations.

3. Intended Use

The spray gun is used for coating suitable substrates with paints and
varnishes as well as wood stains and glazes, up to maximum viscosity of
approx. 150 sec. in the DIN 4 mm flow cup, depending on nozzle size.

4. Description

The compressed air required for spraying is supplied at the compressed
air connection. Pull the trigger to the first pressure point to activate the
pre-air control. Continue pulling the trigger to pull the paint needle out of
the fluid tip: the material flows out of the fluid tip and is atomised by the
compressed air flowing out of the air cap.

5. Scope of Delivery

■ Spray gun with nozzle set RP and aluminium gravity flow cup with air
regulator fitting and pressure gauge (0 – 1.6 bar)
■ Safety valve
■ Air hose for pressure cup
■ Tool kit
■ Operating Instructions
After unpacking, check:
■ Spray gun damaged
■ Complete scope of supply

6. Technical Design

6.1. Spray gun

[1-1] Quick coupling connection
for SM pressurized cup with
check valve
Safety and bleeder valve
[1-2]
Air hose for pressure cup
[1-3]
[1-4] Material flow control with
counter nut
[1-5] Air micrometer
Locking screw
[1-6]
[1-7] Fully variable round/flat fan
control
Pressure gauge for cup
[1-8]
pressure
Air connection
[1-9]
[1-10] Regulation knob
[1-11] Safety valve for regulator
fitting
[1-12] Trigger
EN
123