Sensor Positions - Bosch FWA 4310 Instrucciones De Funcionamiento

en 34 | FWA 43xx / 44xx | Operation
4 .7 .3 Quick clamp
i
Remove the wheel caps if necessary and clean the
rims and pin holes for the clamps.
Make sure that
R
The clamps are firmly attached to the tire
R
The clamping jaws engage properly in the tread
1. Position the clamp with the stop pins in the rim flan-
ge, move the upper one to the rim flange and secure.
2. Press both clamping levers towards the wheel until
they are parallel with the wheel.
3. At the same time press both clamping arms onto the
tread and release the clamping levers. The adjustab-
le clamping arms are to be set such that they engage
firmly in the tread.
After securing, pull out the plug-in handles of the
4.
front clamping levers.
4 .7 .4 Quick clamp
i
If the rims are in perfect condition, there is no need
for run-out compensation on account of the manu-
facturing accuracy of these holders. Run-out com-
pensation is only required if damage to the rims is
suspected.
|
1 690 326 001 2008-09-17
4 .8

Sensor positions

Front left wheel
Rear left wheel
Tab. 3: Sensor positions
i
The sensors have fixed positions on the vehicle as
shown by the following pictograms.
Front right wheel
Rear right wheel
Robert Bosch GmbH