26 6 . Unit Maintenance; 27 6.2 Replacement And Wearing Parts; 28 6.4 Checking The Sensors; 28 6.4.1 Measurement 1 - Toe And Camber - Bosch FWA 4310 Instrucciones De Funcionamiento

6. Unit maintenance
6 .1 Cleaning
R
The housing and the trolley display are only to be
cleaned using a soft cloth and neutral cleaning
agents.
R
Do not use abrasive cleaning agents and coarse
workshop cloths!
R
Use a special fiber cloth to clean the monitor.
6 .2 Replacement and wearing parts
Designation
Turntable
PC unit
Brake clamp
Steering wheel arrester
Sensor
1)
Distributor box
Measurement box
Coated clamping jaws
Non-coated clamping jaws
Cable set
Depending on version (refer to 3.2)
Tab. 5: Replacement and wearing parts
6 .3 Disposal
This FWA 43xx / 44xx is subject to
European guidelines 2002/96/EG (WEEE) .
Old electrical and electronic devices, including-
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of FWA 43xx / 44xx.
Robert Bosch GmbH
Unit maintenance | FWA 43xx / 44xx | 41
6 .4
The sensors are checked by way of reverse
measurement.
6 .4 .1
¶
Interchange the front left and rear right sensors.
¶
Interchange the front right and rear left sensors.
Order number
¶
Use the spirit level to align all the sensors (do not
1 690 311 002
move the vehicle when doing so).
1 693 770 009
¶
Use the connecting cables to connect the sensors to
1 690 401 006
the trolley.
¶
1 690 401 007
Press key <F1> Exit
¶
Key <F9> General view
¶
Turn the steering wheel until the geometrical driving
1 690 501 009
axis display is "0".
1 690 323 007
¶
Perform front and rear total toe measurement in line
1 690 311 003
with the measurement sheet and enter the values.
1 690 311 004
¶
Perform front and rear camber measurement in line
1 690 401 012
with the measurement sheet and enter the values.
6 .4 .2
¶
Drive the vehicle onto the measurement bay - do not
position it on turntables.
¶
Fit the brake clamp.
¶
Secure the quick-action clamps.
¶
Insert the sensors and horizontally align with the
spirit level. Then switch on the FWA 43xx / 44xx.
¶
Use the connecting cables to connect the sensors to
the trolley.
¶
Press key <F1> Exit
¶
Key <F9> General view
¶
Perform front and rear total toe measurement in line
with the measurement sheet and enter the values.
¶
Perform front and rear camber measurement in line
with the measurement sheet and enter the values.
FWA 43xx / 44xx | 41
Checking the sensors
Attach the quick-action clamps to the
wheels. Attach the sensors to the sockets
of the quick-action clamps. Do not move
the vehicle.
Measurement 1 - Toe and camber check in
opposite direction
Measurement 2 - Toe and camber check in
direction of travel
1 690 326 001
| 41 en
|
2008-09-17