Cable-Type Sensor; Radio-Type Sensor - Bosch FWA 4310 Instrucciones De Funcionamiento

3 .3 Sensors
3 .3 .1

Cable-type sensor

!
When removing the cable set, disconnect the
connecting cables by releasing the connector..
not twist the connector as this would destroy the
connector and the cable.
Fig. 3: Long sensor, front and rear
1 CCD camera
2 Spirit level
3 Keypad
4 Data transmission connection
5 Turntable connection
1)
6 Star knob screw for locking rotary encoder
(depending on version)
1)
Fig. 4: Short sensor, rear
1 CCD camera
2 Spirit level
3 Keypad
4 Data transmission connection
Fig. 5: Keypad labels
1 ON key (reset)
2 Run-out compensation key
3 Save/lower vehicle key
4 Run-out compensation indicator
5 "Saving" indicator
6 ON indicator
Robert Bosch GmbH
Product description | FWA 43xx / 44xx | 29
3 .3 .2
i
Wheel alignment can be continued using the cable
set if the batteries are flat or in the event of radio
interference.
Do
!
When removing the cable set, disconnect the
connecting cables by pulling out the connector
vertically. Do not twist the connector as this would
destroy the connector and the cable.
Fig. 6:
1 CCD camera
2 Spirit level
1)
3 Keypad
4 Data transmission connection
5 Turntable connection
6 Star knob screw for locking rotary encoder
7 Antenna
depending on version
1)
Fig. 7:
1 CCD camera
2 Spirit level
3 Keypad
4 Data transmission connection
5 Antenna
Fig. 8:
1 ON key (reset)
2 Run-out compensation key
3 "Saving" key
4 Run-out compensation indicator
5 Save/lower vehicle indicator
6 ON indicator
7 Radio transmitter/receiver indicator
8 Battery indicator:
Off:
Flashing:
On:
FWA 43xx / 44xx | 29

Radio-type sensor

Long sensor, front and rear
1)
Short sensor, rear
Radio-type sensor version
Battery OK
Battery reserve
Battery charging
1 690 326 001
| 29 en
1)
|
2008-09-17