Tiller Handle Installation - TOHATSU M 60C Manual Del Propietário

mended can lead to poor performance of,
and/or damage to, the electrical system.
ENON00006-B
Note
Recommended battery: 12V 70AH/5HR,
800 (Cold Cranking Amps (CCA), In case of
cold whether: 12V100AH/5HR (850CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the outboard
motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery, and
then connect the negative lead (—).
W h e n d i s c o n n e c t i n g t h e b a t t e r y
always remove the negative lead (—)
first. After connecting the positive ter-
minal (+), securely place a cap on it to
prevent short circuits.
1
1. Battery cord (red)
2. Battery cord (black)
ENOM01708-0

5. Tiller handle installation

ENOW01706-0
MFG types
1. Connect the throttle cable coming from
the motor to the handle, then fix it with
a nylon nut. After that, place the plate
in the outer groove, and fix it with
screws.
1. Throttle cable
2. Screw
3. Plate
4. Handle
5. Nylon nut
2. Install the steering handle to the motor
with two bolts.
2
ENOF00022-0
1. Handle
2. Handle B
3. Bolt
4. Plate
5. Friction bolt
6. Bushing
INSTALLATION
1
2
2
3
4
5
ENOF02326-0
2
6
5
4
ENOF02327-0
3
31
5
3
1