Trailering - TOHATSU M 60C Manual Del Propietário

64
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOW00066-A
Do not give a shock to an outboard motor
during transportation. It becames a cause
of breakage.
Keep the outboard motor in a vertical posi-
tion when carrying.
The optional outboard motor stand is rec-
ommended for keeping the outboard
motor vertical both during transport and
storage.
8
ENON00021-A
Note
If the outboard motor must be laid down
be sure drain the fuel and engine oil,
then the port side faces down as shown
in the following drawing.
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
CAUTION
ENOF02361-0
ENOF00680-0
ENOM00072-A

3. Trailering

ENOW00072-0
CAUTION
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
WARNING
Be sure to disconnect fuel connector
except when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
WARNING
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
ENOW00071-0
CAUTION
The tilt support device supplied on your
outboard motor is not intended for towing.
It is intended to support the outboard
motor while the boat is docked, beached,
etc.
When transporting a boat on a trailer with
the outboard motor still attached, discon-
nect the fuel line from the outboard motor
beforehand and keep the outboard motor
in the normal running position or on a tran-
ENOF00075-1