24
INSTALLATION
2
1
1. Bolt (12 mm × length 105 mm)
5
2. Washer (small diameter)
3. Washer (large diameter)
4. Nut
13 ø
1. Top of transom
ENOW00008-A
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
4
3
ENOF02317-0
327 (12.9')
1
51 (2')
17.5 (0.7')
17.5 (0.7')
17.5 (0.7')
251 (9.9')
ENOF02318-0
CAUTION
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 Nm (3.0 kgf) 13 ft-lb)
ENOM00840-A
2. Remote control device
installation
ENOW00944-A
When using other than Tohatsu's genuine
remote control box, DO NOT select the one
without neutral safety switch that prevents
in-gear start.
254
(10')
Use of remote control box without neutral
safety switch can allow start of engine with
gear at other than neutral shift, potentially
leading passengers to falling or causing
passenger to be thrown overboard.
56
(2.2)
It is recommended that you consult w i t h
your authorized dealer for installation
adjustment of the remote control device.
WARNING