28
INSTALLATION
1
1. Cable joint
4. Move the remote control lever to the
5
" F O R W A R D "
"REVERSE" positions to confirm that
the shift is working properly, then set
the lever to "NEUTRAL".
ENOW01706-0
115/140
1. Detach the upper engine cover.
5
4
3
1. Upper grommet
2. For throttle cable
3. For shift cable
4. For cord assembly B
5. For engine cable harness
2. Detach the upper grommet cord clamp
bolt.
3. Detach the throttle and shit cable joints
by removing the R-pins.
ENOF02319-0
" N E U T R A L "
a n d
1
ENOF02321-0
2
4. Move the remote control lever to the
" F O R W A R D "
"REVERSE" positions to confirm that
the shift is working properly, then set
the lever to "NEUTRAL".
3
1. Bolt
2. Cord clamp
3. Upper grommet
2
3
1
1. Shift arm
2. Throttle cable joint
3. Shift cable joint
4. R-pin
5. Washer
5. Double-check that the remote control
cables (i.e., the throttle cable and shift
cable) have been connected correctly.
Move the remote control lever forward
to the first point at which it engages
(approx. 32). The cable which moves
first when the lever is turned should be
the shift cable. Check that the shift
lever is in "NEUTRAL" position and that
the free throttle lever is fully closed
when the remote control cables have
been connected.
" N E U T R A L "
a n d
1
2
ENOF02322-0
4
5
ENOF02323-0