Shallow Water Operation - TOHATSU M 60C Manual Del Propietário

1. Tilt stopper
The outboard motor can also be tilted up
and down using the switch provided under
the bottom cowl.
It is possible to tilt up or down in spite of
main switch "ON" or "OFF".
ENOM00940-0
Manual relief valve
If the battery is dead, and the power tilt
switch thus inoperative, open the manual
valve completely in the Manual direction.
This will allow manual tilting of the out-
board motor.
ENOW00872-0
WARNING
Make sure the manual relief valve is closed
before operating the outboard motor. If the
manual relief valve is not closed, the out-
board motor will tilt up when operated in
reverse.
ENOW00873-0
WARNING
Before opening the manual relief valve,
make sure nobody is under the outboard
motor. If the outboard motor is in the tilted
up position, it will tilt down suddenly if the
manual relief valve is loosened in the "Man-
ual" direction.
1. POWER
2. MANUAL
ENOM00068-A
ENOF02358-0

10.Shallow water operation

ENOW00051-0
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the clamp bracket. Be sure to
tilt the outboard motor down slowly.
ENOW00053-0
While in shallow water drive position, do
not operate the outboard motor in Reverse.
Operate the outboard motor at slow speed
and keep the cooling water intake sub-
merged.
ENOW00054-0
Do not overtilt outboard motor when driv-
ing shallow water, or air may be sucked
through water inlet, potentially leading to
engine overheating.
ENGINE OPERATION
1
2
ENOF00679-0
WARNING
CAUTION
CAUTION
61
7