Fuel System Draining - TOHATSU M 60C Manual Del Propietário

ENOW00066-0
CAUTION
Do not carry or store outboard motor in any
of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
ENON00021-A
Note
If the outboard motor must be laid down
be sure drain the fuel and engine oil,
then the outboard motor on a cushion
as shown in the following drawing (See
page 64 and 85).
Elevate power unit 2 inches to 4 inches if
traveling to avoid air intrusion in the
Power Trim and Tilt pump system.
ENOM00950-A
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh oil and fuel. If the fuel tank
is only partially filled, air in the tank can
cause the fuel to deteriorate during stor-
age.
1. Before adding fuel stabilizer additive,
drain the carburetor (See page 85).
2. Follow the instructions on the label
when adding the fuel stabilizer additive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
If your motor is used occasionally, it is rec-
ENOF01727 0
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container full
to reduce condensation and evaporation.
ENOM00970-A

Fuel system draining

ENOW00028-A
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
If fuel is spilled, wipe it up immediately.
Keep the fuel tank well away from
sources of ignition, e.g. sparks or open
flames
Perform all work outdoors or in a well
ventilated place.
ENOF00680-0
ENOW00097-0
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
dance with local fire prevention and
environment protection regulations.
INSPECTION AND MAINTENANCE
WARNING
WARNING
85
10