Engine Operation; Before Starting; Engine Oil Feeding - TOHATSU M 60C Manual Del Propietário

44

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-C
The engine oil is drained for shipping from
the factory. Be sure to fill the engine oil to
the proper level before starting engine.
(Follow the instruction. See page 35)
1
3
7
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
ENOW00022-B
Be sure to mix the engine oil with gasoline
(Follow the instruction. See page 35)
CAUTION
2
ENOF01963-0
CAUTION
ENOF01710-0
ENOW00027-C
CAUTION
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock and
crank approximately 10 times in order to
circulate the engine oil.
ENOM00656-A

1. Engine oil feeding

When the engine is new or have been left
without operation for a long time, or just
after the engine is overhauled, be sure to
execute the following operation for forc-
edly feeding the engine oil to the oil line
before starting the engine.
a. Disconnect the link rod by turning the
rod snap (1) interlocking with the oil
pump as shown in the figure.
b. Make sure that the oil pump control
lever (2) is set at open side position (3).
c. Idle the engine for more than 30 min-
utes.
d. Reset the link rod (4) to the advancer
arm (5).
60/70
4
1
ENOF02332-0